Arama butonu
Bu konudaki kullanıcılar: 1 misafir
10
Cevap
1349
Tıklama
0
Öne Çıkarma
12~15volt ta çalışabilen tda serisi entegreler
G
19 yıl
Yüzbaşı
Konu Sahibi

TDA7560
SUPERIOROUTPUTPOWERCAPABILITY:
4 x 50W/4ohm MAX.
4 x 45W/4ohm EIAJ
4 x 30W/4ohm @14.4V,1KHz,10%
4 x 80W/2ohm MAX.
4 x 77W/2ohm EIAJ
4 x55W/2ohm @14.4V,1KHz,10%
EXCELLENT 2ohm DRIVINGCAPABILITY
HI-FICLASS DISTORTION
LOWOUTPUTNOISE
ST-BYFUNCTION
MUTEFUNCTION
AUTOMUTEAT MIN.SUPPLYVOLTAGEDE-
TECTION
LOWEXTERNALCOMPONENTCOUNT:
– INTERNALLYFIXEDGAIN(26dB)
– NOEXTERNALCOMPENSATION
– NOBOOTSTRAPCAPACITORS
ONBOARD0.35AHIGHSIDEDRIVER
------------------------------------------------------------------------

TDA8560
2 × 40 W/2ohm
• Requires very few external components
• High output power
• 4 ohm and 2 ohm load impedance
• Low output offset voltage
• Fixed gain
• Diagnostic facility (distortion, short-circuit and
temperature detection)
• Good ripple rejection
• Mode select switch (operating, mute and standby)
• Load dump protection
• Low power dissipation in any short-circuit condition
------------------------------------------------------------------------

TDA1560Q
40W
* Very high output power
* Low power dissipation when used for music signals
* Switches to low output power in the event of excessi heatsink temperatures
* Requires few external components
* Fixed gain
* Low cross-over distortion
* No switch-on/switch-off plops
* Mode select switch
* Low offset voltage at the output
* Load dump protection and across load
* Protected against electrostatic discharge
* Thermally protected
* Diagnostic facility
* Flexible leads.
-------------------------------------------------------------------------

TDA1562Q
70W
• Very high output power, operating from a single low supply voltage
• Low power dissipation, when used for music signals
• Switches to low output power at too high case temperatures
• Few external components
• Fixed gain
• Differential inputs with high common mode rejection
• Mode select pin (on, mute and standby)
• Status I/O pin (class-H, class-B and fast mute)
• All switching levels with hysteresis
• Diagnostic pin with information about:
– Dynamic Distortion Detector (DDD)
– Any short-circuit at outputs
– Open load detector
– Temperature protection.
• No switch-on or switch-off plops
--------------------------------------------------------------------------

TDA8563AQ
2 × 40 W/2
• Requires very few external components
• High output power
• 4 ohm and 2 ohm load impedance
• Low output offset voltage
• Fixed gain
• Diagnostic facility (distortion, short-circuit and temperature detection)
• Good ripple rejection
• Mode select switch (operating, mute and standby)
• Load dump protection and across the load
• Short-circuit safe to ground, to Vp
• Low power dissipation in any short-circuit condition
-----------------------------------------------------------------------------

TDA7375
2 x 35WDUAL/QUAD POWER AMPLIFIER
HIGHOUTPUTPOWERCAPABILITY:
•2 x 40Wmax./4ohm
•2 x 35W/4ohm EIAJ
•2 x 35W/ohm EIAJ
•2 x 25W/4ohm @14.4V,1KHz,10%
•4 x 7W/4ohm @14.4V,1KHz,10%
•4 x 12W/2ohm @14.4V,1KHz,10%
•MINIMUM EXTERNAL COMPONENTS
COUNT:
– NOBOOTSTRAPCAPACITORS
– NOBOUCHEROTCELLS
– INTERNALLYFIXEDGAIN(26dBBTL)
•ST-BYFUNCTION(CMOSCOMPATIBLE)
•NOAUDIBLEPOPDURINGST-BYOPERATIONS
DIAGNOSTICSFACILITYFOR:
– CLIPPING
– OUTTOGNDSHORT
– OUTTOVs SHORT
– SOFTSHORTAT TURN-ON
– THERMALSHUTDOWNPROXIMITY
Protections:
•OUPUTAC/DCSHORTCIRCUIT



arkadaşlar elimdekilerinin data sheetleri bunlar merak ettiginiz varsa yazın data sheet ini ve özelliklerini eklerim

DH forumlarında vakit geçirmekten keyif alıyor gibisin ancak giriş yapmadığını görüyoruz.

Üye olduğunda özel mesaj gönderebilir, beğendiğin konuları favorilerine ekleyip takibe alabilir ve daha önce gezdiğin konulara hızlıca erişebilirsin.

Üye Ol Şimdi Değil





< Bu mesaj bu kişi tarafından değiştirildi Gry054 -- 20 Ocak 2007; 23:11:47 >