Profil: Uygar55

U

Uygar55 (UYGAR AKDAG)
Web Tasarım ve Hazır Kodlar altına konu açtı.

2 yıl

int led = 13;
int sensor = 2;
int state = LOW;
int val = 0;
void setup() {
pinMode(led, OUTPUT);
pinMode(sensor, INPUT);
Serial.begin(9600);
}
void loop(){
val = digitalRead(sensor);
if (val == HIGH) {
digitalWrite(led, HIGH);
delay(100);
if (state == LOW) {
Serial.println("Hareket
Basladi");
state = HIGH;
}
}
else {
digitalWrite(led, LOW);
delay(200);
if (state == HIGH){
Serial.println("Hareket
Durdu");
state = LOW;
}

U

Uygar55 (UYGAR AKDAG)
Elektronik altına konu açtı.

2 yıl

servo

#include <Servo.h>
Servo motor;
int pot = A0;

void setup() {
motor.attach(5);
pinMode(pot, INPUT);
}
void loop() {
int potokunan = analogRead(pot);
int aci = map(potokunan, 0, 1023, 0, 180);
motor.write(aci);
delay(10);
}

U

Uygar55 (UYGAR AKDAG)
Elektronik altına konu açtı.

2 yıl

park

const int trigger_pin = 12;
const int echo_pin = 13;
const int buzzer = 2;
const int mled = 3;
const int yled = 4;
const int sled = 5;
const int kled = 6;
int sure;
int mesafe;
void setup()
{ pinMode(kled, OUTPUT);
pinMode(sled, OUTPUT);
pinMode(yled, OUTPUT);
pinMode(mled, OUTPUT);
pinMode(buzzer, OUTPUT);
pinMode(trigger_pin, OUTPUT);
pinMode(echo_pin, INPUT);
Serial.begin(9600);}
void loop()
{ digitalWrite(trigger_pin, HIGH);
delayMicroseconds(1000);
digitalWrite(trigger_pin, LOW);
sure = pulseIn(echo_pin, HIGH);
mesafe = (sure / 2) / 28.5;
if (mesafe <= 10) { digitalWrite(kled, HIGH);
digitalWrite(buzzer, HIGH);
delay(50);
digitalWrite(kled, LOW);
digitalWrite(buzzer, LOW);
delay(250); }
else if (mesafe <= 25)
{ digitalWrite(sled, HIGH);
digitalWrite(buzzer, HIGH);
delay(50);
digitalWrite(sled, LOW);
digitalWrite(buzzer, LOW);
delay(500); }
else if (mesafe <= 50) {
digitalWrite(yled, HIGH);
digitalWrite(buzzer, HIGH);
delay(50);
digitalWrite(yled, LOW);
digitalWrite(buzzer, LOW);
delay(750); }
else {
digitalWrite(mled, HIGH);
delay(1000);
digitalWrite(mled, LOW);
delay(1000);
}
}